Seite 1 von 1

Petronix Ignitor - Einbau im Distributor

Verfasst: So 20. Sep 2020, 19:23
von coco
nur Frage zum richtigen Verständnis
pertronix-7.jpg
pertronix-7.jpg (104.23 KiB) 777 mal betrachtet
der Abstand vom Ignitor zum Plastikring soll nur 0,76mm sein, korrekt?

0.03" = 0.76 mm -> also kein voller mm

"set the air gap betwenn the module and magnet slevve using the provided plastic feeler gauge (0.030" thick). this is done in the manner as points. note: in same kits the modules are stationay and not not require air gapping"

Ich habe leider nicht das beschriebene plastik teil und muss wohl mit fühlerlehren arbeiten.

Re: Petronix Ignitor - Einbau im Distributor

Verfasst: So 20. Sep 2020, 19:35
von tonilepo
Hi Frank,
nimm einfach eine Plastik karte/ Bankkarte ;) passt .

Gruß Stephan

Re: Petronix Ignitor - Einbau im Distributor

Verfasst: So 20. Sep 2020, 19:45
von torf
Die Pertronix ist da flexibel - stell 0,030" ein und es sollte passen..... mache laufen auch mit 0,050"

Re: Petronix Ignitor - Einbau im Distributor

Verfasst: So 20. Sep 2020, 20:48
von forstmeister
Genau, die Clubkarte ist auch ausgezeichnet dafür geeignet :D
karte.JPG
karte.JPG (54.38 KiB) 720 mal betrachtet

Re: Petronix Ignitor - Einbau im Distributor

Verfasst: So 27. Sep 2020, 13:56
von coco
danke euch nochmals :D